![]() ![]() We also sometime experiences some issues with USB devices when the system is rebooted using the coldboot option of update tool, an hardware reset is recommended to avoid those problems. If you are updating to version 1.1beta2 please consider that the "output enabling polarity" (oep) parameter of the display configuration has been changed to match the behaviour it has on our other modules. ![]() This means that you should change its value from 0 to 1 or viceversa to keep the display working if you rely on this signal. If you are updating to version 1.1beta4 please consider that you need to clear registry or to change those registry entries to be able to access flashdisk and sd card If you are using default display configuration you can just clean the registry to keep default behaviour. ![]() ![]() Make sure there is no SD card inserted in the carrier board in order to enter recovery mode properly If you already updated your bootloader and image using the update tool you don't need to use recovery mode or perform an update from the bootloader, so you can skip the next chapters. Recovery mode is needed only if your module is currently booting Linux or not booting at all. If you already installed a previous version of Windows CE you can jump to the "Flashing or updating bootloader" section. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |